By Marissa Velazquez


Hear loss and other disorders related to the sense of hearing are usually monitored using an instrument called an audiometer. It is calibrated with standardized units of measure to obtain the accurate results concerning the disorder. The test requires to be done in a room that is quite and is fitted with soundproof material. The patient is usually given a set of headphones to put on the ears. He is then expected to remain seated and be calm.

The headphones are then attached to a device that produces tones at varied frequencies and different intensity. The audiologist then waits to see the patient raise a hand in acknowledgement of sound heard. To specify the ear that picks the sound, you are expected to raise the corresponding hand to the ear, which is either left or right hand respectively. There is also the provision of buttons to confirm hearing by the patient. The results are then studied and recorded on an audiogram.

There are many conditions that can cause a person to lose his ability to hear. Acoustic neuroma is one of such conditions. This is a slow growing tumor on the cranial nerve which is responsible for hearing and balance. Apart from hear loss it also causes facial paralysis.

A damaged eardrum or ossicle can cause conductive hearing loss. Damaged vestibulocochlear nerve can result to Sensorineural hearing loss. Sometimes a person can experience buzzing sounds which are also called tinnitus. Vertigo is another condition if not managed properly can result to hearing loss.

There are a number of tests than can be done to check for hearing ability. This are carried out according to the type of patient and the reason the test is to be done. The type of patient can be a newborn baby, young children or even adults. Children are not able to say when they have hearing problems. The audiologist has to use special equipments to test them. The principle followed in testing children is the same but the way of doing it may vary to be able to obtain more accurate results.

An otoacoustic emission test is most preferred to test babies. This is because the test is simple to carryout, takes a very short time and the child feels no pain. It involves the placing in the childs ear a tiny earpiece attached to a microphone and a loudspeaker. A clicking sound is then produced by the speaker, which is transmitted to the cochlea. If the cochlea is functioning properly, the sound will be sent back to the ear canal and picked by the microphone.

A case where no sound is heard could mean an hearing problem though other factors have to be ruled out. These factors can be an unsettled child, a noisy room or even the presence of some fluid in the ear after birth. The test has to be done several times and if not satisfactory another more sensitive test called automated auditory brainstem response is done. Both tests have to be done when the child is asleep to avoid interruption.

Young children are tested using a technique called reinforcement audiometry. Speakers are used to relay the sounds in the testing room and the child responds by turning towards the sound outlet. Every time this is done, the audiologist has to reward the child to keep him motivated. The frequencies are changed at different levels to see if the child can hear even at the lowest sound. Testing much older children and adults is done by use of pure tone audiometry technique. An audiometer is used to transmit sounds through headphones at different pitches and levels.




About the Author:



0 comments :